In the command, make sure to change the -InterfaceIndex value with the correct number of the network adapter you want to apply an automatic metric. Set-NetIPInterface -InterfaceIndex 21 -AutomaticMetric enabled Type the following command to see the new metric applied to the network adapter and press Enter:Īfter completing the steps, Windows 10 will prioritize the network traffic depending on your configuration when multiple network adapters are connected to the network.Īt any time, you can go back to the previous behavior allowing Windows 10 to decide the network adapter priority using these steps: Also, remember that a lower metric number means higher priority, and a higher metric number means lower priority. In the command, make sure to change the -InterfaceIndex value to reflect the network adapter you want to prioritize and change the -InterfaceMetric value to assign a priority. Set-NetIPInterface -InterfaceIndex 21 -InterfaceMetric 10 Type the following command to change the priority order of the network adapter and press Enter: Type the following command to identify the current interface metric and interface index number and press Enter:

Search for Windows PowerShell, right-click the top result a select Run as administrator.

How to change network adapter priorities using PowerShellĪlternatively, you can change network adapters priorities on a device with multiple interfaces using PowerShell with these steps: 9, make sure to check the Automatic metric option. (Usually, you will be using the TCP/IPv4 protocol.)Īt any time, you can revert the changes using the same instructions, but on step No. The only caveat using the Control Panel experience is that depending on your network setup, you may need to adjust the metric for the Internet Protocol Version 6 (TCP/IPv6) as well, if that's the protocol you're using. Once you've completed the steps, Windows 10 will prioritize the network traffic depending on your configuration.

Quick Tip: The lower the metric number means higher priority, and a higher number indicates lower priority. In the 'Interface metric' field assign a priority value for the adapter. In the 'General' tab, click the Advanced button.

Select the Internet Protocol Version 4 (TCP/IPv4) item.Right-click the network adapter you want to prioritize, and select Properties. If you want to change the order in which Windows 10 uses network adapters, do the following: How to change network adapter priorities using Control Panel How to change network adapter priorities using PowerShell.How to change network adapter priorities using Control Panel.

In this Windows 10 guide, we'll walk you through the steps to change the network adapter priorities to stay connected using your prefered adapter when using multiple interfaces.

Lenovo wifi adapter windows 10